Q-NOTE QN-7000HX Specifications download pdf (Page 33)

SMS 7000 Release Notes 29

Hardware, Firmware, and Software Installation

Inquire of the Main MCPU parameters ﬁrst, and then with the Backup

MCPU installed and the Main MCPU removed repeat the process. The

Back-up MCPU uses slightly a different name and IP address. In the ex-

ample below, Backup MCPU(s) name and IP address are indicated in

brackets [] to the right of the Main MCPU entries.

You should see something similar to the following displayed at the sys-

tem console:

boot device: fi

processor number: 0

host name: PC

file name: SMS

inet on ethernet (e): 192.0.2.2:ffffff00

[192.0.2.3:ffffff00]

host inet (h): 192.0.2.1

user (u): smsuser

ftp password (pw): smsuser

flags (f): 0x8

target name (tn): sms7000[sms7000b]

other (o): sl (for SLIP)ei (for Ethernet)

Using the c command, change the boot device boot parameter from

fi (FLASH) to sl for SLIP or ei for Ethernet.

SMS7000 Boot> c

You are prompted to change each line of parameters.

CAUTION

Do not change parameters other than those indicated here!

Simply hit

to skip over them.

Type @ at the SMS7000 Boot> prompt to begin the download:

SMS7000 Boot> @

You will see a message at the 7000 console indicating that the MCPU

software is being downloaded to ﬂash. Three numbers will eventually

appear to the right of this message. Each number displayed is the size

of a MCPU program segment. The size of each segment is displayed af-

ter the segment is copied into the ﬂash memory. The FTPD program at

the PC will report status as well.

If you do not see

FTPD Status...Connection, Log in, and

Disconnect

dialog at the PC running FTPD, return to Install Application

Software on page 21!

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

No comments

Q-NOTE QN-7000HX Specifications Page 33