18 SMS 7000 Release Notes
Version 6.41
Install UART Mezzanine
This is to be used when upgrading SMS-64V Systems with Amezi Serial
Control only.
Some Compact System (SMS-64V) configurations may use a Controller
Module with an Amezi card in the #2 mezzanine position running Native
Protocol. These systems do not have the capability to run a system termi-
nal.
To install new MCPU Application Software on these systems, the Amezi
mezzanine must be temporarily replaced with a UART mezzanine to run
the system terminal. The MCPU module is configured with a UART mez-
zanine in the lower mezzanine position and an Amezi mezzanine in the up-
per mezzanine position.
Figure 2. Amezi Mezzanine Location
To Change the Amezi to a UART Mezzanine:
1. On the PC, at the pc dos prompt, use ping to verify that the network
interface works properly.
Enter the following commands:
For MCPU #1
C:\> ping sms7000
For MCPU #2
C:\> ping sms7000b
The system should respond as follows:
C:\> sms7000 (192.0.2.2) is alive
If not, refer to the Series 7000 Configuration Manual, and verify the prop-
er installation of PC NFS and SLIP Network Interface.
mezzanine
position #2
(standard)
MCPU
module
UART Mezzanine
required here to support
the terminal
3504/54-01
Comments to this Manuals